Honeywell Tuxedo Touch Wi-Fi - Network Connections; Setup a WLAN (Wi-Fi) Connection

Remote Access (cont'd)
40
Network Connections
From the "Home" screen, press the Setup and IP Setup icons.
Select a type of network connection : LAN ON or WIFI ON and press Save .
Go to that section below for further information.
Setup a LAN Connection
Press the LAN ON button. A pop-up window displays:
This will switch off WLAN Network, do you want to continue? Yes or No
Connect an Ethernet cable between the router and the keypad; the IP address and default gateway
address of the router is displayed.
If the IP address is not displayed, change the “Internet Connection Type” to Static and manually enter
the IP address from your router onto the keypad. Highlight each field and enter the required
information for Subnet Mask, Default Gateway, DNS Server and Port #; press GO.
To change the default port number (6280), press the field next to port number enter a secondary port
number between 5000-65534. A pop-up window displays:
“Success Network Details Saved”….“Port number changed. Keypad is going to reset”
The keypad reboots with the newly configured port number.
Press the Save icon; the IP information is automatically updated.
At your PC, Smart Phone or Tablet browser, start your browser and enter your IP Address.
Setup a WLAN (Wi-Fi) Connection
Press the WIFI ON button. A pop-up window displays:
“This will switch off LAN Network, do you want to continue?” Yes or No.
Use the scroll bar to locate a network from the list of Wi-Fi Networks to connect to and highlight that
field.
Or, scroll to the bottom of the list and select Add Network. Highlight each field to enter the required
information for SSID, Security Mode, Passphrase/Shared Key, and Port #.
To change the default port number (6280), press the field next to port number and enter a secondary
port number between 5000-65534. A pop-up window displays:
“Success Network Details Saved”
“Port number changed. Keypad is going to reset”
A pop-up window displays the message: “Settings saved.” Select OK to save.
Press the Save icon; pressing Save when changing the port number resets the keypad.
At your PC, Smart Phone or Tablet browser, start your browser and enter your IP Address.