FAASTFLEX FAAST FLEX Product Guide
www.xtralis.com 35
Event
Codes
Description Event
Codes
Description
103 Bluetooth module error 1103 Exit from bluetooth module error
106 CH1 sensing head communication fault
1106 Exit from CH1 sensing head communication
fault
107 Aspirator failure 1107 Exit from Aspirator fault
109 CH1 flow is below the min limit 1109 Exit from CH1 Low flow fault
110 CH1 flow is above the max limit 1110 Exit from CH1 High flow fault
112 CH2 sensing head communication fault
1112 Exit from CH2 sensing head communication
fault
114 CH2 flow is below the min limit 1114 Exit from CH2 Low flow fault
115 CH2 flow is above the max limit 1115 Exit from CH2 High flow fault
116 Overvoltage error
1
117 Unauthorised configuration change 1117 Not used
118 Data Flash fault
1
119 Memory Fault
2
120 CH1 Dust Contamination
3
1120 Exit from CH1 dirt fault
121 CH2 Dust Contamination
3
1121 Exit from CH2 dirt fault
127 Enable buzzer for buttons over
128 EEPROM byte writing failure
201 Clock cannot be read or set 1201 Exit from clock alert
202 Clock data is not consistent 1202 Exit from Invalid time base alert
203 CH1 High Temperature Alert 1203 Exit from CH1 High temperature alert
204 CH1 Low Temperature Alert 1204 Exit from CH1 Low temperature alert
205 CH2 High Temperature Alert 1205 Exit from CH2 High temperature alert
206 CH2 Low Temperature Alert 1206 Exit from CH2 Low temperature alert
207 Low power alert 1207 Exit from Low power alert
208
CH1 Sensing Head Dust Contamination
Level 1
4
1208 Exit from CH1 Sensing Head Dust
Contamination Level 1
209
CH1 Sensing Head Dust Contamination
Level 2
5
1209 Exit from CH1 Sensing Head Dust
Contamination Level 2
210
CH2 Sensing Head Dust Contamination
Level 1
4
1210 Exit from CH2 Sensing Head Dust
Contamination Level 1
211
CH2 Sensing Head Dust Contamination
Level 2
5
1211 Exit from CH2 Sensing Head Dust
Contamination Level 2
212 Low power alert, possible loss of events
1212 Exit from Low power alert, events will not be
written
251 Service fault
1
252 Initialization fault
1
1
Switch into PROTECTION mode
2
Switch into SERVICE mode
3
Drift level 100%
4
Drift level 40%
5
Drift level 70%
To Next Page
Loading...
Need help?
General
