63
[Switch] domain dm1
# Configure the ISP domain to use RADIUS scheme rs1.
[Switch-isp-dm1] authentication portal radius-scheme rs1
[Switch-isp-dm1] authorization portal radius-scheme rs1
[Switch-isp-dm1] accounting portal radius-scheme rs1
[Switch-isp-dm1] quit
# Configure dm1 as the default ISP domain for all users. Then, if a user enters a username without any
ISP domain at login, the authentication and accounting methods of the default domain will be used for
the user.
[Switch] domain default enable dm1
• Configure portal authentication
# Configure the portal server.
[Switch] portal server newpt ip 10.1.1.1 key portal port 50100 url
http://10.1.1.1:8080/portal
# Enable portal authentication on the interface connecting the host.
[Switch] interface vlan-interface 2
[Switch-Vlan-interface2] portal server newpt method direct
[Switch-Vlan-interface2] quit
4. Verify the configuration
The user can initiate portal authentication by using the iNode client or by accessing a web page. All of
the initiated web requests will be redirected to the portal authentication page at
http://10.1.1.1:8080/portal. Before passing portal authentication, the user can access only the
authentication page. After passing portal authentication, the user can access the Internet.
After the user passes the portal authentication, use the following command to view the portal user
information on the switch.
[Switch] display portal user interface vlan-interface 2
Index:19
State:ONLINE
SubState:NONE
ACL:NONE
Work-mode:stand-alone
MAC IP Vlan Interface
---------------------------------------------------------------------
0015-e9a6-7cfe 192.168.1.58 2 Vlan-interface2
Total 1 user(s) matched, 1 listed.
# Use the display connection command to view the connection information on the switch.
[Switch] display connection
Index=20 ,Username=portal@dm1
IP=192.168.1.58
IPv6=N/A
MAC=00-15-E9-A6-7C-FE
Total 1 connection(s) matched.
To Next Page
Loading...
Need help?
General