HP 3600 v2 Series Security Configuration Guide

65
• Select LAN Access Service as the service type
• Select HP(A-Series) as the access device type
• Select the switch from the device list or manually add the switch whose IP address is 10.1.1.2
• Adopt the default settings for other parameters and click OK to finish the operation.
NOTE:
The IP address of the access device specified here must be the same as the source IP address of the RADIUS
packets sent from the switch, which is the IP address of the outbound interface by default, or otherwise the
IP address specified with the nas-ip or radius nas-ip command on the switch.
Figure 27 Add an access device
# Add a charging policy.
Click the Service tab, and select Accounting Manager > Charging Plans from the navigation tree to enter
the charging policy configuration page. Then, click Add to enter the Add Charging Plan page and
perform the following configurations:
• Add a plan named UserAcct
• Select Flat rate as the charging template
• In the Basic Plan Settings field, configure to charge the fixed fee of 120 dollars per month
• In the Service Usage Limit field, set the Usage Threshold to 120 hours, allowing the user to access
the Internet for up to 120 hours per month
• Adopt the default settings for other parameters and click OK to finish the operation.

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English