29
Figure 40 Removing the filler panel over an interface card slot
3. Hold the captive screws on the front panel of the interface card, and gently push the interface card
in along the slot guide rails until the interface card is in close contact with the switch chassis (see
callout 1 in Figure 41.)
4. Tighten the captive screws with a Phillips screwdriver to secure the interface card in the slot (see
callout 2 in Figure 41).
Figure 41 Installing an interface card
Figure 42 LSP5GT8P in the chassis
To Next Page
Loading...
Need help?
General
