32
Figure 39 Setting terminal emulation in Switch Properties dialog box
Powering on the switch
Verification before power-on
Before powering on the switch, verify that:
• The power cord is properly connected.
• The input power voltage meets the requirement of the switch.
• The console cable is properly connected, the terminal or PC used for configuration has started,
and the configuration parameters have been set.
Powering on the switch
Power on the switch (for example, an 5830AF-48G switch), and you can see the following
information:
System is starting...
Booting Normal Extend BootWare....
The Extend BootWare is self-decompressing.....................Done!
****************************************************************************
* *
* HP A5830AF BootWare, Version 1.03 *
To Next Page
Loading...
Need help?
General
