27
The next time you attempt to log in through the console port, you do not need to provide any username
or password, as shown in Figure 8.
Figure 8 Accessing the
CLI through the console port without authentication
Configuring password authentication for console login (not
supported in FIPS mode)
Ste
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter AUX user interface view.
user-interface aux first-number
[ last-number ]
N/A
3. Enable password
authentication.
authentication-mode password
By default, you can log in to the
device through the console port
without authentication and have
user privilege level 3 after login.
4. Set a password.
set authentication password
{ cipher | simple } password
By default, no password is set.
5. Configure common settings
for console login.
See "Configuring common console
login settings (
optional)."
Optional.
The next time you attempt to log in through the console port, you must provide the configured login
password, as shown in Figure 9.
To Next Page
Loading...
Need help?
General
