HP 5830 series User Manual

34
Authentication
mode
Configuration tasks Reference
Password
Enable password authentication on the VTY user
interface.
Set a password.
"Configuring password
authentication for Telnet
login"
AAA
Enable scheme authentication on the VTY user interface.
Configure local or remote authentication settings.
To configure local authentication:
1. Configure a local user and specify the password.
2. Configure the device to use local authentication.
To configure remote authentication:
1. Configure the RADIUS or HWTACACS scheme on
the device.
2. Configure the username and password on the AAA
server.
3. Configure the device to use the scheme for user
authentication.
"Configuring scheme
authentication f
or Telnet
login"
Disable authentication for Telnet login
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable Telnet server.
telnet server enable By default, the Telnet server is enabled.
3. Enter one or multiple
VTY user interface
views.
user-interface vty first-number
[ last-number ]
N/A
4. Disable
authentication.
authentication-mode none
By default, password authentication is
enabled for VTY user interfaces.
5. Configure the
command level for
login users on the
current user
interfaces.
user privilege level level
By default, the default command level
is 0 for VTY user interfaces.
6. Configure common
settings for the VTY
user interfaces.
See "Configuring common settings for
VTY user interfaces (optional)."
Optional.
The next time you attempt to Telnet to the device, you do not need to provide any username or password,
as shown in Figure 12. If the max
imum number of login users has been reached, your login attempt fails
and the message "All user interfaces are used, please try later!" appears.

HP 5830 series Specifications

General

Brand	HP
Model	5830 series
Category	Switch
Language	English