HP 5830 series User Manual

35
Figure 12 Telnetting to the device without authentication
Configuring password authentication for Telnet login
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable Telnet.
telnet server enable
By default, the Telnet service is
enabled.
3. Enter one or multiple VTY
user interface views.
user-interface vty first-number
[ last-number ]
N/A
4. Enable password
authentication.
authentication-mode password
By default, password
authentication is enabled for
VTY user interfaces.
5. Set a password.
set authentication password { cipher |
simple } password
By default, no password is set.
6. Configure the user privilege
level for login users.
user privilege level level The default level is 0.
7. Configure common settings
for VTY user interfaces.
See "Configuring common settings for
VTY user interfaces (optional)."
Optional.
The next time you attempt to Telnet to the device, you must provide the configured login password, as
shown in Figure 13. If th
e maximum number of login users has been reached, your login attempt fails and
the message "All user interfaces are used, please try later!" appears.
Figure 13 Password authentication interface for Telnet login

HP 5830 series Specifications

General

Brand	HP
Model	5830 series
Category	Switch
Language	English