HP 5830 series

60
[Sysname-acl-basic-2000] rule 2 permit source 10.110.100.46 0
[Sysname-acl-basic-2000] quit
# Reference ACL 2000 in user interface view to allow Telnet users from Host A and Host B to access the
Device.
[Sysname] user-interface vty 0 4
[Sysname-ui-vty0-4] acl 2000 inbound
Configuring source IP-based SNMP login control
Use a basic ACL (2000 to 2999) to control SNMP logins by source IP address. To access the requested
MIB view, an NMS must use a source IP address permitted by the ACL.
Configuration procedure
To configure source IP-based SNMP login control:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Create a basic ACL and
enter its view, or enter the
view of an existing basic
ACL.
acl [ ipv6 ] number acl-number [ name name ]
[ match-order { config | auto } ]
By default, no basic ACL
exists.
3. Create an ACL rule.
rule [ rule-id ] { deny | permit } [ counting |
fragment | logging | source { sour-addr
sour-wildcard | any } | time-range
time-range-name | vpn-instance
vpn-instance-name ] *
N/A
4. Exit the basic ACL view.
quit N/A