HP 5830 series User Manual

30
Ste
p
Command Remarks
7. Apply an AAA
authentication scheme to
the intended domain.
a. Enter ISP domain view:
domain domain-name
b. Apply an AAA scheme to
the domain:
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name
[ local ] | local | none |
radius-scheme
radius-scheme-name
[ local ] }
c. Exit to system view:
quit
Optional.
By default, local authentication is
used.
For local authentication, configure
local user accounts.
For RADIUS or HWTACACS
authentication, configure the
RADIUS or HWTACACS scheme on
the device and configure
authentication settings (including the
username and password) on the
server.
For more information about AAA
configuration, see Security
Configuration Guide.
8. Create a local user and
enter local user view.
local-user user-name By default, no local user exists.
9. Set an authentication
password for the local user.
password { cipher | simple }
password
• In non-FIPS mode:
password [ [ hash ] { cipher |
simple } password ]
• In FIPS mode:
password
By default, no password is set.
10. Specifies a command level
of the local user.
authorization-attribute level level
Optional.
By default, the command level is 0.
11. Specify terminal service for
the local user.
service-type terminal
By default, no service type is
specified.
12. Configure common settings
for console login.
See "Configuring common console
login settings (
optional)."
Optional.
The next time you attempt to log in through the console port, you must provide the configured login
username and password, as shown in Figure 10.

HP 5830 series Specifications

General

Brand	HP
Model	5830 series
Category	Switch
Language	English