EasyManuals Logo

HP 5830 series User Manual

HP 5830 series
170 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
32
Ste
p
Command
Remarks
6. Specify the number of data
bits in a character.
databits { 7 | 8 }
By default, the number of data bits in
each character is 8.
The setting depends on the character
coding type. For example, you can
set it to 7 if standard ASCII
characters are to be sent, and set it
to 8 if extended ASCII characters
are to be sent.
7. Define a shortcut key for
starting a terminal session.
activation-key character
By default, press Enter to enable a
terminal session.
8. Define a shortcut key for
terminating tasks.
escape-key { default | character }
By default, pressing Ctrl+C
terminates a task.
9. Configure the flow control
mode.
flow-control { hardware | none |
software }
By default, the flow control mode is
none.
The device supports only the none
mode.
10. Specify the terminal display.
terminal type { ansi | vt100 }
By default, the terminal display type
is ANSI.
The device supports two terminal
display types: ANSI and VT100. HP
recommends that you set the display
type to VT100 on both the device
and the configuration terminal. If
either side uses the ANSI type, a
display problem such as cursor
positioning error might occur when
a command line has more than 80
characters.
11. Configure the user privilege
level for login users.
user privilege level level
By default, the default command
level is 3 for the AUX user interface.
12. Set the maximum number of
lines to be displayed on a
screen.
screen-length screen-length
By default, a screen displays 24
lines at most.
A value of 0 disables pausing
between screens of output.
13. Set the size of command
history buffer.
history-command max-size value
By default, the buffer saves 10
history commands at most.
14. Set the idle-timeout timer.
idle-timeout minutes [ seconds ]
The default idle-timeout is 10
minutes. The system automatically
terminates the user's connection if
there is no information interaction
between the device and the user
within the idle-timeout time.
Setting idle-timeout to 0 disables the
timer.

Table of Contents

Other manuals for HP 5830 series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 5830 series and is the answer not in the manual?

HP 5830 series Specifications

General IconGeneral
BrandHP
Model5830 series
CategorySwitch
LanguageEnglish

Related product manuals