69
Press CTRL+K to abort
Connected to 10.1.1.1.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(10.1.1.1:(none)):abc
331 Give me your password, please
Password:
230 Logged in successfully
# Set the file transfer mode to binary.
[ftp] binary
200 Type set to I.
# Download the system software image file newest.bin from the PC to the IRF fabric:
• Download the file newest.bin from the PC to the Flash root directory of the master device.
[ftp] get newest.bin
227 Entering Passive Mode (10,1,1,1,10,68).
125 BINARY mode data connection already open, transfer starting for /newest.bin.
226 Transfer complete.
FTP: 23951480 byte(s) received in 95.399 second(s), 251.00K byte(s)/sec.
• Download the file newest.bin from the PC to the Flash root directory of the subordinate device (with
member ID of 2).
[ftp] get newest.bin slot2#flash:/newest.bin
227 Entering Passive Mode (10,1,1,1,10,68).
125 BINARY mode data connection already open, transfer starting for
slot2#flash:/newest.bin.
226 Transfer complete.
FTP: 23951480 byte(s) received in 95.399 second(s), 251.00K byte(s)/sec.
# Set the transfer mode to ASCII and upload the configuration file config.cfg from the IRF fabric to the PC
for backup.
[ftp] ascii
[ftp] put config.cfg back-config.cfg
227 Entering Passive Mode (10,1,1,1,4,2).
125 ASCII mode data connection already open, transfer starting for /config.cfg.
226 Transfer complete.
FTP: 3494 byte(s) sent in 5.646 second(s), 618.00 byte(s)/sec.
[ftp] bye
221 Server closing.
# Specify newest.bin as the main system software image file for the next startup of all member devices.
<Sysname> boot-loader file newest.bin slot all main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 1!
The specified file will be used as the main boot file at the next reboot on slot 2!
IMPORTANT:
The system software image file used for the next startup must be saved in the Flash root directory. You can
copy or move a file to the Flash root directory.
# Reboot the device, and the system software image file is updated at the system reboot.
<Sysname> reboot
To Next Page
Loading...
Need help?
General
