5. Press [Return] and wait for either the Main menu, or the copyright
screen (if a password has been set) with a prompt for you to type the
password.
Note If your console is set to 9600 baud, you should have to press [Return] only
once. If the console is set to another speed, you may have to press [Return]
more than once.
6. If the Copyright screen appears, type the password and press [Return].
The Main menu screen then appears. The system has booted.
Note If neither the Copyright screen nor the Main menu appears, press [Return]
again, pause, and then repeat if necessary. (Speed sensing may require
more than one [Return] for your type of connection.) If pressing [Return]
several times does not establish the console connection, refer to chapter
3, “Troubleshooting.”
Figure 1-12. Main Menu Screen
Figure 1-13. Copyright and Password
Screen
Installation
Plug in and verify router hardware.
1-19
To Next Page
Loading...
Need help?
General
