HP 650 User Manual

5. Grasping the left and right ends of the bezel, pull out until the tray is
about half exposed.
6. Grasping the sides of the tray, remove the interface card from the
router.
Note If you are not ready to install the new interface card now, reinstall the
card blank using the next three steps described below for installing the
new interface card. (All slots must be filled, either with card blanks or
with interface cards—you should not use the router with a slot open.)
7. Holding the new interface card by the sides of its tray, slide the back
of the tray about half-way into the router.
8. Pull the locks on the bezel outward, then push evenly on both ends
until the card fully engages and the locks swing inward to about 45°.
(See figure 3-5.)
Figure 3-4. Disengaging Card Bezel
Troubleshooting
Replacing a Module
3-23

HP 650 Specifications

General

RAM	Up to 8GB DDR3
Display	15.6-inch HD (1366x768)
Graphics	Intel HD Graphics
Operating System	Windows 7 / Windows 8
Battery	6-cell Li-ion
Optical Drive	DVD±RW
Wireless	802.11b/g/n
Processor	Intel Celeron, Pentium, or Core i3/i5/i7 (various models available)