HP photosmart 715 user guide8
Previewing your pictures
Instead of looking through the viewfinder to frame a picture, you
can use the image display to preview a picture. The image display
shows exactly what your picture will look like, whereas the
viewfinder shows an image area smaller than what the camera
actually captures. Preview your picture on the image display when
precise framing is important, especially when you are taking a
close-up shot.
Note Using the image display consumes a lot of battery
power. To conserve battery power, the camera
automatically turns off the image display after 60
seconds if you do not press a button.
To preview a picture
1 Press the PREVIEW ( ) button to turn on the image display.
2 Frame your picture in the image display by pointing the camera
lens at your subject.
3 Press and hold the
SHUTTER button halfway down to allow the
camera to adjust the focus and exposure.
4 When you see the steady green light to the right of the
viewfinder, press the
SHUTTER button all the way down to take
the picture. Wait for the beeps that indicate that your picture
has been taken, and then release the
SHUTTER button.
To turn off the image display, press the button.
HUG.book Page 8 Tuesday, September 25, 2001 1:03 PM
To Next Page
Loading...
