HP photosmart 715 user guide38
Unloading images to a Macintosh computer
Unloading is the process of copying images from the CF memory
card in the camera to a computer.
You can unload images from your camera in two ways:
automatically, or by mounting the camera as a disk drive. The
automatic unload procedure is described below.
Note To conserve battery power, use an HP-approved AC
adapter (optional) when you are unloading images
to a computer.
To automatically unload images to a Macintosh computer
1 Connect the camera to your computer by using the USB cable.
2 Turn on the camera.
The status LCD displays PC to indicate the camera is
connected to a computer.
3 If the welcome screen appears on your computer screen, click
OK.
4 After a few seconds, the Automatic Image Unload window
appears. When the countdown timer expires, the software
begins unloading new images from the camera to the
computer. To pause the automatic unload, click Pause.
You can set up your Automatic Image Unload software so that
certain tasks occur automatically after the images are unloaded
from the camera. To gain access to these options, click Options.
When all the new images have been unloaded to your computer,
the ArcSoft PhotoImpression software opens and you can view,
edit, print, and create projects with your images.
For more information, see the ArcSoft software Help.
HUG.book Page 38 Tuesday, September 25, 2001 1:03 PM
To Next Page
Loading...
Need help?
General
