HP photosmart 715 user guide50
The camera
does not turn
on.
(continued)
The AC adapter is
not functioning
correctly.
Check the following conditions:
• The AC power adapter is plugged
into an electrical outlet
• There is power at the outlet.
• The AC power adapter is not
damaged.
• Make sure you are using the correct
HP-approved AC adapter.
You have an AC
power adapter
connected to the
camera, but it is not
connected to a
power source.
When you have an AC adapter
connected to the camera, the camera
does not use battery power even if the
adapter is not connected to a power
source. If you want to use battery power,
disconnect the AC adapter from the
camera. If you want to use AC power,
connect the AC adapter to a working
electrical outlet.
The camera
does not
respond when
I press a
button.
The camera is off.
Slide the switch to turn on
the camera (if you want to take a picture)
or turn on the image display (if you want
to review your images).
The camera is
connected to a
computer.
If the status LCD displays the letters
PC, the camera buttons do not respond.
The batteries are
empty.
Replace the batteries.
The camera needs
to be reset.
Turn the camera off and then on again.
Remove the batteries and reinstall them.
If you are using an AC power adapter,
disconnect the adapter from the camera,
remove and reinstall the batteries, and
then reconnect the adapter.
Problem Possible cause Solution
HUG.book Page 50 Tuesday, September 25, 2001 1:03 PM
To Next Page
Loading...
Need help?
General
