HP 8712ES - Page 389

ES User’s Guide 8-83
Hardkey/Softkey Reference
S
Softkey in the user TTL config menu. Displays a pop-up message with
a description of softkey sequencing and softkeys to enable or disable
the auto-step function.
See "Measurement Setup and Control with Fast Recall" in the
Automating Measurements User’s Guide Supplement for more
information.
Access Keys:
Softkey in the character entry menu. Adds a blank space to a title or
filename.
Softkey in the menu. Used in conjunction with .
Selects the frequency span of the source. When selected, it changes the
frequency annotation from start/stop to center/span.
See “Entering Measurement Parameters” on page 2-4 for more
information.
Softkey in the more display menu. Toggles the display mode between
split (measurement channel 1 on top, measurement channel 2 on the
bottom) and full (both measurement channels on full screen).
See “Entering Measurement Parameters” on page 2-4 for more
information.
Access Keys:
Softkey in the spur avoid options menu. If this option is selected, the
analyzer switches between the default and an alternate configuration
during a sweep to avoid spurs.
NOTE Sweeptime usually increases when this option is
selected.
See “Reducing Trace Noise” on page 5-12 for more information.
CAUTION The measurement calibration must be performed
with the same spur avoid option used in the
measurement or your results may be invalid.
Access Keys:
Softkey
Auto-Step
SYSTEM OPTIONS
System Config
User TTL Config
Space
Span
FREQ
Center
Split Disp
FULL split
DISPLAY
More Display
Spur Avoid
MENU
Spur Avoid Options