HP 8712ES - Page 392

8-86 ES User’s Guide
Hardkey/Softkey Reference
S
Softkey in the update correction constants menu. Writes a copy of CC
data from internal volatile RAM to EPROM. This function is used so
that current CC data is not lost when power to the analyzer is turned
off.
See the Service Guide for more information.
Access Keys:
Softkey in the LAN port setup menu. Allows you to enter the numbers
that your network administrator assigned to your analyzer. If you were
not assigned a subnet mask, leave the setting at 0.0.0.0 (default value)
to disable subnet masking.
See The LAN Interface User’s Guide Supplement for more information.
Access Keys:
Hardkey in the SOURCE area of the front panel. Displays the menu to
select automatic sweep time (fastest possible), manual sweep,
alternate sweep, or power sweep.
Softkey in the user TTL config menu. Sets the USER TTL IN/OUT port
on the rear panel to be pulled to a high TTL level during a sweep.
See “Analyzer Connectors—Rear Panel BNC Connectors” on page 7-4
for more information.
Access Keys:
Softkey in the menu. Sets the sweep time from fastest
possible to three days (259.2 ks); overrides auto sweep time. Fastest
possible sweeptime varies, and depends on other analyzer settings.
See Chapter 5 for more information on sweep time.
Softkey in the menu. Sets the network analyzer to sweep as
fast as possible (automatic) or at the sweep time of your choice
(manual).
See Chapter 5 for more information on sweep time.
Store CC
To EPROM
SYSTEM OPTIONS
Service
Update Corr Const
Subnet Mask
SYSTEM OPTIONS
LAN
LAN Port Setup
SWEEP
Sweep Out
SYSTEM OPTIONS
System Config
User TTL Config
Sweep Time
SWEEP
Sweep Time
AUTO man
SWEEP