HP 8712ES - Page 393

ES User’s Guide 8-87
Hardkey/Softkey Reference
S
Softkey in the system config menu. Configures the analyzer for use
with a multiport test set.
Refer to the multiport test set User's and Service Guide for more
information.
Access Keys:
Softkey in the menu. Displays the data formatted as SWR
(standing wave ratio).
Softkey in the CRT adjust menu. Toggle to ON for use with a
sync-on-green external monitor. The default setting is toggled to OFF.
Access Keys:
Softkey in the menu. Displays the menu to set the bandwidth of
the IF filters in the receiver section of the network analyzer.
See “To Reduce the Receiver Noise Floor” on page 5-10 and the
following table for more information on system bandwidth.
Switching
Test Set
SYSTEM OPTIONS
System Config
SWR
FORMAT
Sync Green
on OFF
SYSTEM OPTIONS
System Config
CRT Adjust
System
Bandwidth
AVG
System BW Dynamic Range Sweep Speed Approximate BW
Wide
Medium Wide (default)
Medium
Medium Narrow
Narrow
Fine
Low
Medium
Medium
Medium
High
High
Fastest
Faster
Fast
Slow
Slower
Slowest
6500 Hz
4000 Hz
3700 Hz
1200 Hz
250 Hz
15 Hz