To Next Page

To Previous Page

Chapter 1 21

Installing and Conﬁguring 10/100Base-TX/9000

Step 1: Check the 10/100Base-TX Installation Prerequisites

shown in “Table 1: 10/100Base-TX/9000 Card Summary.”

*The speed conﬁguration of the 10/100Base-TX card is determined by

the speed setting of the hub or switch port to which the card is

connected. The card automatically senses this speed. The card only

runs at one speed at a time. To verify the speed selection, use the

LED indicators on the front of the 10/100Base-TX card as shown

below or run lanadmin and check the link speed and duplex mode at

the LAN Interface Status Display.

6. You have super-user status.

NOTE The only Application Programmatic Interface (API) supported by the

10/100Base-TX /9000 product is the Data Link Provider Interface

(DLPI). Refer to the DLPI Programmer’s Guide for more detailed

information .

Table 1-1 10/100Base-TX/9000 Card Summary

Category 10/100Base-TX

UTP Connection 8-pin RJ45

Speed

10 Mbit/s or 100 Mbit/s

Conﬁgure Speed At hub or switch port

LED on Card Yes

Card Selftest Yes

Half-Duplex Yes

Full-Duplex Yes

Conﬁgure Duplex

Mode

Half-Duplex at hub or

full-duplex at switch.

Autonegotiation Yes

Download from Www.Somanuals.com. All Manuals Search And Download.

Other manuals for HP 9000 Series

Questions and Answers:

Need help?

Do you have a question about the HP 9000 Series and is the answer not in the manual?

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome