42 Chapter3
100Base-TX Resources
HP-UX Manual Reference Pages
HP-UX Manual Reference Pages
While installing, configuring, or troubleshooting 10/100Base-TX, you
may need to refer to any of the following online manual reference pages
(man pages) for useful HP-UX operating system or 10/100Base-TX
commands. To display a man page, type the following at the system
prompt: man <command name>. For example, man arp.
• arp(1M) displays and modifies the Internet-to-station address
mapping tables used by the Address Resolution Protocol.
• hosts(4) is a database that contains a single line entry for each host
name entry.
• ifconfig(1M) assigns anaddress to a network interface, and configures
and displays network parameters.
• ioscan(1M) scans system hardware, usable I/O system devices, or
kernel I/O system data structures as appropriate, and lists the
results.
• lanadmin(1M) resets or reports the status of the LAN card.
• lanconfig(1M) sets/resets the packet encapsulation method for a
network interface. Applicable only to HP-UX 10.20 or earlier.
• lanscan(1M) displays information about LAN cards that are
successfully bound to the system.
• linkloop(1M) verifies network connectivity through the Data Link
Layer (OSI Layer 2).
• netfmt(1M) formats common tracing and logging binary files.
• netstat(1) provides network statistics and information about network
connections.
• nettl(1M) logs network events and traces packets as they enter and
exit the 10/100Base-TX driver.
• ping(1M) verifies network connectivity through the Network Layer
(OSI Layer 3) and reports the round-trip time of communications
between the local and remote hosts.
• route(1M) adds and deletes entries to the network routing table.
• sam(1M) configures networking software.
Download from Www.Somanuals.com. All Manuals Search And Download.
To Next Page
Loading...
Need help?
General
