Chapter 1 29
Installing and Configuring 10/100Base-TX/9000
Step 6: Configure the 10/100Base-TX Link
Step 6: Configure the 10/100Base-TX Link
NOTE Make sure the 10/100Base-TX card and software are installed in the
system before you use SAM to configure the software.
NOTE The instructions below are for the Motif version of the System
Administration Manager (SAM). To activate the X11 software on your
system, you must first run the command: .
export DISPLAY=
system name
:0.0
Log in as root and do the following:
1. At the HP-UX prompt, type: sam
2. Double click Networking and Communications at the SAM main
window.
3. Double click Network Card Configuration at the Networking and
Communications window.
4. Highlight the HP-PB 10/100Base-TX interface card that you want to
configure from the object list. If the card is not displayed, then go
back to Step 3 “Access the System Card Bay” and check that your
hardware has been properly installed.
NOTE The term 10/100Base-TX on the display indicates that a 10/100Base-TX
card is present. To determine the speed of the 10/100Base-TX card you
must run lanadmin and reference the link speed at the LAN Interface
Status Display or check the 10 and 100 Mbit/s LEDs on the
10/100Base-TX card.
The SAM object list always shows the name of the built-in LAN
(IEEE802.3/Ethernet) as lan0 and the first networking card in an
HP-PB slot as lan1. The networking cards installed in other slots are
named sequentially (lan2, lan3, etc.), according to the order of the
occupied slots.
Download from Www.Somanuals.com. All Manuals Search And Download.