HP 9000 Series Instruction Manual

Chapter 4 69
Troubleshooting 10/100Base-TX/9000
Diagnostic Flowcharts
Flowchart 4 Procedures
A, Execute: netfmt. Use the netfmt command to view log
data (error and disaster messages). An example
command is shown below.
netfmt -v -f /var/adm/nettl.LOG00 | more
B. Check causes and actions on display in the
formatted log output. Use the time stamp to find the
proper logs. Ensure that you are looking at the
10/100Base-TX information.
C. Problem solved. If yes, go to flowchart 1. If not,
continue with step D.
D. Execute lanadmin. Run lanadmin(1M). For a
complete description of this command, refer to the
lanadmin(1M) on-line manual page.
E. Select LAN from Menu. Select lan from the menu to
enter LAN Interface Diagnostic.
F. Select the PPA (NMID) and enter the
10/100Base-TX NMID. You can use the lanscan
command to find the current PPA (NMID) for
10/100Base-TX. The PPA (NMID) you enter becomes
the current device to be tested.
G. Reset the card according to Steps D through G in
Flowchart 4. Using the reset command in lanadmin
re-executes the LAN card self-test.
Reset successful? The reset is successful if no errors
are displayed as a result of the reset command. If the
self-test was successful, the problem may be that you
are not connected to the 10/100Base-TX network.
Correct the problem and verify the resolution by
continuing with flowchart 1. Otherwise, go to flowchart
4A.
Download from Www.Somanuals.com. All Manuals Search And Download.

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome