HP 9000 Series Instruction Manual

Chapter 4 63
Troubleshooting 10/100Base-TX/9000
Diagnostic Flowcharts
Flowchart 2a Procedures
I. Either 10 Mbit or 100 Mbit LED = ON? If yes, go to
step K.
J. If either 10 Mbit or 100 Mbit LED = OFF, check
connection to hub or switch. Reset card
according to Steps D through G in Flowchart
4.Go back to flowchart 1.
K. Does Link speed match what you expect? If it
does, proceed to step M
L. If Link speed does not match what you expect,
set attached hub or switch to the correct link
speed. Reset card according to Steps D through
G in Flowchart 4.Go back to flowchart 1.
M. Check duplex mode on switch port. Is the duplex
mode set to the same duplex mode on both the
card and the switch port? If it is, proceed to step
O.
N. Set attached switch port to the same duplex mode on
both the card and the switch. Reset card according to
Steps D through G in Flowchart 4. Go back to flowchart
1.
O. Does Activity LED come on during test? If the
Activity LED does not come on, Call HP. If it does come
on, go to flowchart 3.
Download from Www.Somanuals.com. All Manuals Search And Download.

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome