Chapter 4 67
Troubleshooting 10/100Base-TX/9000
Diagnostic Flowcharts
The class and driver fields alone will indicate
“unknown” status if the kernel has not been generated.
If the driver has not been generated, continue to step
H. If the driver is in the kernel, go to step G.
F. Verify or edit /stand/system and regen kernel.
Verify/edit /stand/system contains theekeyword. If
not, see “Creating a New Kernel” in chapter 3 of the
Installing and Administering LAN/9000 Software
manual for instructions on how to edit /stand/system
to create a new kernel.
G. Check hardware. Verify that the network card is
seated correctly and that it is operational.
H. Reboot the system.
I. Problem fixed? If you have found the 10/100Base-TX
card problem, stop. If not, start again with flowchart 1.
Download from Www.Somanuals.com. All Manuals Search And Download.
To Next Page
Loading...
