HP 9000 Series Instruction Manual

88 AppendixA
10/100Base-TX Interface Card Statistics
RFC 1213 MIB II
Administration Status
The desired state of theinterface. This parameter is set
to up(1) and is not configurable. It will have one of the
following values:
Operation Status
The current operational state of the interface. This
value is the same as the hardware status displayed by
lanscan(1M). It will have one of the following values.
Last Change
The value of SysUpTime at the time the interface
entered its current operational state. If the current
state was entered prior to the last reinitialization of the
local network management subsystem, then this object
contains a zero value.
Inbound Octets
The total number of octets received on the interface,
including framing characters.
Inbound Unicast Packets
The number of subnetwork-unicast packets delivered
to a high-layer protocol.
Inbound Non-Unicast Packets
The number of non-unicast (subnetwork-broadcast or
up(1) Ready to pass packets
down(2) Not operative
testing(3) In test mode
up(1) Ready to pass packets
down(2) Not operative (card is down)
testing(3) In test mode
Download from Www.Somanuals.com. All Manuals Search And Download.

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome