A-Class Server Installation
A-Class Server Power Up and Boot Procedures
Chapter 2
54
After entering this information, press OK. The final screen in this series will appear:
NOTE Disregard step 2, “Connect the serial cable from the system to the Secure Web Console.”
Step 2 applies only to the stand-alone version of the HP Secure Web Console product. In
A-class servers, this product is already installed internally.
Press OK to continue.
NOTE Pressing OK will NOT reboot the A-Class server. It will only reboot the Secure Web
Console. A-Class server boot procedures are included in the following section.
Accessing the Secure Web Console
Enter the IP address of the Web Console (the IP address is the address for the Web
Console port) in the web browser “Location:” window. Enter the user name and
password, when prompted. From the HP Secure Web main screen, click on Access
Console.
For additional information regarding the HP Secure Web Console, enter the following
URL: http://eproducts.hp.com/.
To Next Page
Loading...
Need help?
General