Installing Hardware Options
6. Remove the tray by loosening the thumbscrew securing the hard drive trays to
the chassis (1) and sliding the tray toward the rear of the server and lifting (2).
Figure 3-18: Removing the hard drive tray
IMPORTANT: These servers ship with the ATA cables already installed. The module cables
are threaded through the opening in the center wall and are connected to the ATA module.
The device connectors lay in the hard drive bay.
HP ProLiant DL320 Generation 2 Server Setup and Installation Guide 3-23
HP CONFIDENTIAL
Writer: Anna Roberts File Name: d-ch3 Installing Hardware Options.doc
Codename: MoonStar Part Number: 293166-002 Last Saved On: 1/31/03 11:16 AM
To Next Page
Loading...
