HP Elite 8300 Series Small Form Factor User Manual

Power Switch/LED Assembly
Description Spare part number
Power switch/LED assembly 646828-001
1. Prepare the computer for disassembly (Preparation for Disassembly on page 75).
2. Remove the access panel (
Computer Access Panel on page 123).
3. Remove the front bezel (
Front Bezel on page 124).
4. Remove the front fan (
Front Fan Assembly on page 147).
5. Disconnect the cable from the system board connector labeled PB/LED.
6. With the computer on its side, press on the tabs on the bottom of the assembly (1) to disengage
the assembly from the chassis, and then rotate the bottom of the assembly upward (2) to
remove it from the chassis.
Figure 7-29 Removing the power switch/LED
7. Pull the assembly away from the chassis while threading the cable through the hole in front of
the chassis.
150 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis

HP Elite 8300 Series Small Form Factor Specifications

General

Brand	HP
Model	Elite 8300 Series Small Form Factor
Category	Desktop
Language	English