EasyManuals Logo
Home>HP>Desktop>Elite Slice G2

HP Elite Slice G2 Service Manual

HP Elite Slice G2
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
A Power cord set requirements
The power supplies on some computers have external power switches. The voltage select switch feature on
the computer permits it to operate from any line voltage between 100-120 or 220-240 volts AC. Power
supplies on those computers that do not have external power switches are equipped with internal switches
that sense the incoming voltage and automatically switch to the proper voltage.
The power cord set received with the computer meets the requirements for use in the country where you
purchased the equipment.
Power cord sets for use in other countries must meet the requirements of the country where you use the
computer.
General Requirements
The requirements listed below are applicable to all countries:
1. The power cord must be approved by an acceptable accredited agency responsible for evaluation in the
country where the power cord set will be installed.
2. The power cord set must have a minimum current capacity of 10A (7A Japan only) and a nominal voltage
rating of 125 or 250 volts AC, as required by each country’s power system.
3. The diameter of the wire must be a minimum of 0.75 mm
2
or 18AWG, and the length of the cord must be
between 1.8 m (6 feet) and 3.6 m (12 feet).
The power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits
from the product.
WARNING! Do not operate this product with a damaged power cord set. If the power cord set is damaged in
any manner, replace it immediately.
Japanese Power Cord Requirements
For use in Japan, use only the power cord received with this product.
CAUTION: Do not use the power cord received with this product on any other products.
96 Appendix A Power cord set requirements

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Elite Slice G2 and is the answer not in the manual?

HP Elite Slice G2 Specifications

General IconGeneral
Bus typeDMI3
Processor cache6 MB
Processor modeli5-7500T
Processor threads4
Processor frequency2.7 GHz
Processor cache typeL3
Processor manufacturerIntel
Processor boost frequency3.3 GHz
Number of processors installed1
Configurable TDP-down frequency1.7 GHz
ECCNo
Internal memory8 GB
Memory clock speed2400 MHz
Internal memory typeDDR4-SDRAM
Maximum internal memory- GB
Memory layout (slots x size)2 x 4 GB
SSD capacityThe Solid State Drive's storage capacity in Gigabytes.
SSD interfaceNVMe
Storage mediaSSD
SSD form factorM.2
Total storage capacity128 GB
Intel Identity Protection Technology version1.00
Sustainability certificatesENERGY STAR
Discrete graphics card modelNot available
On-board graphics card modelIntel® HD Graphics 630
Maximum on-board graphics card memory64 GB
Antenna type2x2
Bluetooth version4.2
Top Wi-Fi standardWi-Fi 5 (802.11ac)
WLAN controller modelIntel Dual Band Wireless-AC 8260
Ethernet LAN data rates10, 100, 1000 Mbit/s
USB 2.0 ports quantity0
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity2
Chassis typeUSFF
Product colorBlack
Country of originChina
Audio chipConexant CX7501
Product typePC
Motherboard chipsetIntel® Q170
Operating system installedWindows 10 IoT Enterprise
HP segmentBusiness
Power supply90 W
Weight and Dimensions IconWeight and Dimensions
Width165 mm
Height112 mm
Weight1520 g
Package depth596 mm
Package width203 mm
Package height273 mm
Package weight6670 g

Related product manuals