HP Elite Slice G2

M.2 PCIe solid state drive (SSD)
The computer oers both 2.5-inch and M.2 solid-state drives, which are installed in dierent locations.
An M.2 solid-state drive socket is available on the system board under the fan sink. For more information
about removing a 2.5-inch solid-state drive, see 2.5-inch, solid-state drive (SSD) on page 26.
Description
256 GB, PCIe, NVMe, TLC
256 GB, PCIe, NVMe, value
To remove the solid-state drive:
1. Remove the access panel (Access panel on page 21).
2. Remove the Base Module (Base Module on page 30).
3. Remove the fan sink (Fan sink on page 37).
4. Locate the solid state drive on the system board.
5. Remove the screw securing the solid state drive to the system board.
38 Chapter 4 Removal and replacement procedures – HP Elite Slice Base Module