HP Elite Slice G2

Memory
Description
Memory modules (PC4-2400-MHz)
8-GB
4-GB
The memory module slots on the system board can be populated with up to two industry-standard memory
modules. At least one small outline, dual inline memory module (SODIMM) is preinstalled. To achieve the
maximum memory support, you can populate the system board with up to 32 GB (16 GB x 2) of memory.
NOTE: Dual channel memory is recommended for Microsoft Skype Room Systems for better performance.
Memory module specications
For proper system operation, the SODIMMs must adhere to the following specications:
●
industry-standard 288-pins
●
unbuered non-ECC PC4-17000 DDR4-2133 MHz-compliant
●
1.2 volt DDR4-SDRAM SODIMMs
●
Support CAS latency 15 DDR4 2400 MHz (15-15-15 timing)
●
Contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specication
The computer supports the following:
●
512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies
●
Single-sided and double-sided SODIMMS
●
SODIMMs constructed with x8 and x16 devices
NOTE: To avoid compatibility issues, HP recommends that you use only HP memory modules in this
computer. The system will not operate properly if you install unsupported DIMM memory. DIMMs constructed
with x4 SDRAM are not supported.
22 Chapter 4 Removal and replacement procedures – HP Elite Slice Base Module