HP HPE Apollo 2000 Gen10 Plus - Page 48

102 pages

To Next Page

To Previous Page

If the ambient temperature sensor cable in the left bezel ear remains secured in its protective foam, carefully

release the cable.

• Right bezel ear

Removal and replacement procedures

Main Page

Table of Contents3
Illustrated Parts Catalog6
Mechanical Components6
Rack Rail Spare Kit6
SFF Drive Blank Spare Part6
System Components6
Fan Board Spare Part7
Power Backplane Spare Part7
Power Distribution Board Spare Part8
Power Interface Board Spare Parts8
Power Supply Spare Parts8
Fan Spare Part8
System Interconnect Assembly Spare Part8
Bezel Ear Assembly Spare Parts9
System Cable Spare Kit9
Chassis Options9
Drive Backplane Spare Parts10
Energy Pack Spare Part10
RCM Board Spare Part10
Customer Self Repair11
Removal and Replacement Procedures20
Safety Considerations20
Electrostatic Discharge20
Symbols on Equipment20
Rack Warnings and Cautions21
Server Warnings and Cautions22
Preparation Procedures24
Power down the Server24
Remove the Hot-Plug Drive24
Remove the Power Supply25
Remove the Server Blank26
Disconnect the Tube Set27
Remove the Server27
Extend the Chassis from the Rack28
Remove the Chassis from the Rack29
Remove the Access Panel31
Install the Chassis into the Rack32
Connect the Tube Set34
Power up the Server34
Removing and Replacing the Rack Rails35
Removing and Replacing a Drive Blank37
Removing and Replacing a Power Supply38
Power Supply Warnings and Cautions38
Remove and Replace an AC Power Supply38
Removing and Replacing a Hot-Plug Drive39
Removing and Replacing a Fan40
Removing and Replacing a Drive Backplane Power Cable41
Removing and Replacing the Fan Board42
Removing and Replacing a Drive Backplane44
Removing and Replacing the Bezel Ear Assembly46
Removing and Replacing the System Interconnect Assembly50
Removing and Replacing the Energy Pack52
Removing and Replacing the PIB54
Removing and Replacing the Power Backplane56
Removing and Replacing the PDB59
Removing the PDB59
Replacing the PDB62
Removing and Replacing the RCM Sideband Cable65
Removing and Replacing the RCM Board66
Removing and Replacing the APM Module Cable68
Troubleshooting71
NMI Functionality71
Troubleshooting Resources71
Diagnostic Tools72
Product Quickspecs72
UEFI System Utilities72
Selecting the Boot Mode72
Secure Boot73
Launching the Embedded UEFI Shell73
Ilo Service Port74
Intelligent Provisioning74
HPE Insight Remote Support75
HPE Infosight for Servers75
USB Support76
External USB Functionality76
HPE Smart Storage Administrator76
Component Identification77
System Components77
Front Panel Components77
Information Pull Tab79
Front Panel Leds and Buttons79
Front Panel LED Power Fault Codes81
Chassis UID LED81
UID Button Functionality81
Rear Panel Components82
Rear Panel Leds and Buttons83
Server Node Numbering83
Server Node Orientation84
Drive Configurations84
Node-To-Drive Association84
Drive Numbering85
HPE Smart Carrier Drive Leds and Components85
Fan Numbering87
Fan Board Connectors88
Power Backplane-Distribution Board Components88
Cabling89
Cabling Guidelines89
Front I/O Cabling90
Drive Backplane Cabling91
N2600 8 SFF U.3 Drive Backplane Cabling91
N2600 24 SFF Basic Drive Backplane Cabling92
Energy Pack Cabling93
APM Module Cabling93
RCM Sideband Cabling94
Specifications95
Environmental Specifications95
Mechanical Specifications95
Power Supply Specifications96
HPE 1600 W Flex Slot Platinum Hot-Plug Low Halogen Power Supply96
HPE 1800 W-2200 W Flex Slot Platinum Hot-Plug Power Supply97
HPE 3000 W 200-277 VAC Platinum Hot-Plug Power Supply97
Websites99
Support and Other Resources100
Accessing Hewlett Packard Enterprise Support100
Accessing Updates100
Remote Support101
Warranty Information101
Regulatory Information101
Documentation Feedback102

HP HPE Apollo 2000 Gen10 Plus - Page 48

Table of Contents

Related product manuals