HP MSM3xx User Manual

Security
Using an external RADIUS server
6-10
 Acct-Output-Gigawords (32-bit unsigned integer): High 32-bit value of the number of
octets/bytes sent by the user. Only present when Acct-Status-Type is Interim-Update or
Stop. As defined in 2869.
 Acct-Output-Octets (32-bit unsigned integer): Low 32-bit value of the number of octets/
bytes sent by the user. Only present when Acct-Status-Type is Interim-Update or Stop.
Acct-Output-Packets (32-bit unsigned integer): Number of packets sent by the user.
Only present when Acct-Status-Type is Interim-Update or Stop.
 Acct-Session-Id (32-bit unsigned integer): Random value generated by the AP.
 Acct-Session-Time (32-bit unsigned integer): Number of seconds since this session was
authenticated.
 Acct-Status-Type (32-bit unsigned integer): Supported values are Accounting-Start (1),
Accounting-Stop (2), and Accounting-On (7) and Accounting-Off (8).
Acct-Terminate-Cause (32-bit unsigned integer): Termination cause for the session.
Only present when Acct-Status-Type is Stop. Supported causes are: Idle-Timeout, Lost-
Carrier, Session-Timeout, and User-Request. See RFC 2866 for details.
 Called-Station-Id (string):
 802.1X: BSSID of the VSC. By default, the value address is sent in IEEE format. For
example: 00-02-03-5E-32-1A. The format can be changed in the Wireless protection
section of the VSC > Profiles page.
 MAC: MAC Address of the radio (Network > Ports page). By default, the MAC
address is sent in IEEE format. For example: 00-02-03-5E-32-1A. The format can be
changed in the Wireless protection section of the VSC > Profiles page.
 Calling-Station-Id (string): The MAC address of the wireless client station in IEEE
format. By default, the MAC address is sent in IEEE format. For example: 00-02-03-5E-32-
1A. The format can be changed in the Wireless protection section of the VSC >
Profiles page.
 Class (string): As defined in RFC 2865. Multiple instances are supported.
 Framed-IP-Address (32-bit unsigned integer): IP Address as configured on the client
station (if known by the AP).
 Framed-MTU (32-bit unsigned integer): Hard-coded value of 1496. The value is always
four bytes lower than the wireless MTU maximum which is 1500 bytes in order to support
IEEE802.1X authentication.
 NAS-Identifier (string): The NAS ID set on the Security > RADIUS page for the profile
being used.
 NAS-Port (32-bit unsigned integer): A virtual port number starting at 1. Assigned by the
AP.
 NAS-Port-Type (32-bit unsigned integer): Always set to 19, which represents
WIRELESS_802_11.
 User-Name (string): The RADIUS username provided by the 802.1X client.

HP MSM3xx Specifications

General

Brand	HP
Model	MSM3xx
Category	Wireless Access Point
Language	English