Resetting to factory defaults
Factory defaulting ruggedized products
D-5
To reset a ruggedized product to factory defaults, follow this procedure:
1. Disconnect any cable from the AP.
2. Disconnect power from the PoE injector.
3. Configure your computer LAN port with a static IP address of 192.168.1.2 and a subnet
mask of 255.255.255.0.
4. Use a Cat 5 Ethernet crossover cable to connect your computer LAN port directly to the
PoE injector Data In port.
5. Connect a Cat 5 Ethernet cable from the PoE injector Data and Power Out port directly
to the AP.
6. Open a command line session on the computer.
7. In the folder containing the script, specify the script name including its language
identifier and the factory parameter like this:
MSMRemote-en factory
Press Enter to execute the script.
8. Power on the PoE injector. The script performs the reset and confirms success with a
message like this:
Your "R" product has been successfully factory reset!
9. Once the factory reset completes, perform the procedure found in the Initial software
configuration section of the AP Quickstart.
To Next Page
Loading...
Need help?
General
