Wireless configuration
Radio configuration
3-21
this can cause collisions with any 802.11b clients present on the same channel. However,
the AP uses protection mechanisms (RTS/CTS or CTS-to-self) when sending 802.11n data
to prevent disruption to legacy (802.11a/b/g) clients associated on the same channel.
802.11n/b/g
HP refers to this mode as Compatibility mode because the AP allows both 802.11n and
legacy clients to associate. The AP advertises protection in the beacon when legacy
clients are associated or operating on the same channel. This alerts associated 802.11n
clients to use protection when transmitting. The AP also uses protection mechanisms
(RTS/CTS or CTS-to-self) when sending 802.11n data to prevent disruption to legacy
clients associated on the same channel.
802.11b
This is a legacy mode that can be used to support older wireless client stations.
802.11b/g
This is a legacy mode that can be used to support older wireless client stations.
Supported on MSM410, MSM422 (radio 1)
Frequency band 2.4 GHz
Data rates For 802.11n clients: Up to 130 Mbps. (Up to 300 Mbps when
using a 40 MHz channel width, which is not recommended in the
2.4 GHz frequency band.)
For 802.11g clients: Up to 54 Mbps.
For 802.11b clients: Up to 11 Mbps.
Supported on MSM310, MSM320, MSM335, MSM410, MSM422
Frequency band 2.4 GHz
Data rates Up to 11 Mbps.
Supported on MSM310, MSM320, MSM335, MSM410, MSM422
Frequency band 2.4 GHz
Data rates For 802.11g clients: Up to 54 Mbps.
For 802.11b clients: Up to 11 Mbps.
To Next Page
Loading...
Need help?
General
