Wireless configuration
Viewing wireless information
3-41
QoS low priority tx
Total number of QoS low priority packets that have been sent.
QoS medium priority tx
Total number of QoS medium priority packets that have been sent.
QoS high priority tx
Total number of QoS high priority packets that have been sent.
QoS very high priority tx
Total number of QoS very high priority packets that have been sent.
Tx packets
(Not shown on the E-MSM460)
The total number of packets transmitted.
Tx dropped
(Not shown on the E-MSM460)
The number of packets that could not be transmitted. This can occur when the wireless
configuration is being changed.
Tx errors
(Not shown on the E-MSM460)
The total number of packets that could not be sent due to the following errors: Rx retry limit
exceeded and TX discards wrong SA.
Rx packets
(Not shown on the E-MSM460)
The total number of packets received.
Rx dropped
(Not shown on the E-MSM460)
The number of received packets that were dropped due to lack of resources on the AP. This
should not occur under normal circumstances. A possible cause could be if many client
stations are continuously transmitting small packets at a high data rate.
Rx multicast octets
The number of octets received successfully as part of multicast (including broadcast)
MSDUs. These octets include MAC Header and Frame Body of all associated fragments.
Rx unicast octets
The number of octets received successfully as part of unicast MSDUs. These octets include
MAC Header and Frame Body of all associated fragments.
To Next Page
Loading...
Need help?
General
