EasyManuals Logo

HP MSR4080 User Manual

HP MSR4080
471 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
105
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] ntp-service ipv6 multicast-server ff21::1
Related commands
ntp-service ipv6 multicast-client
ntp-service ipv6 source
Use ntp-service ipv6 source to specify the source interface for IPv6 NTP messages.
Use undo ntp-service ipv6 source to restore the default.
Syntax
ntp-service ipv6 source interface-type interface-number
undo ntp-service ipv6 source
Default
No source interface is specified for IPv6 NTP messages. The device automatically selects the source IP
address for IPv6 NTP messages. For more information, see RFC 3484.
Views
System view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
If you specify the source interface for IPv6 NTP messages, the device sets the source IP address of the IPv6
NTP messages to the primary IP address of the specified interface when sending the IPv6 NTP messages.
When the device responds to an IPv6 NTP request, the source IPv6 address of the NTP response is
always the IPv6 address of the interface that has received the IPv6 NTP request.
If you do not want the IPv6 address of a certain interface on the local device to become the destination
address for response messages, use the command.
• If you have specified the source interface for IPv6 NTP messages in the ntp-service ipv6
unicast-server or ntp-service ipv5 unicast-peer command, the interface specified in the ntp-service
ipv6 unicast-server or ntp-service ipv6 unicast-peer command works as the source interface for
IPv6 NTP messages. If you have configured the ntp-service ipv6 broadcast-server or ntp-service
ipv6 multicast-server command, the source interface for the broadcast or multicast NTP messages
is the interface configured with the respective command.
• If the specified source interface is down, the device does not send IPv6 NTP messages.
Examples
# Specify the source interface of IPv6 NTP messages as GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] ntp-service ipv6 source gigabitethernet 2/0/1

Table of Contents

Other manuals for HP MSR4080

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP MSR4080 and is the answer not in the manual?

HP MSR4080 Specifications

General IconGeneral
BrandHP
ModelMSR4080
CategoryNetwork Router
LanguageEnglish

Related product manuals