HP MSR4080

147
[Sysname-GigabitEthernet2/0/1] poe enable
# Enable PoE on a PI in PoE profile view.
<Sysname> system-view
[Sysname] poe-profile abc
[Sysname-poe-profile-abc-1] poe enable
Related commands
• display poe interface
• poe-profile
poe enable pse
Use poe enable pse to enable PoE for a PSE.
Use undo poe enable pse to restore the default.
Syntax
poe enable pse pse-id
undo poe enable pse pse-id
Default
PoE is disabled on PSEs.
Views
System view
Predefined user roles
network-admin
Parameters
pse-id: Specifies a PSE by its ID.
Examples
# Enable PoE for PSE 7.
<Sysname> system-view
[Sysname] poe enable pse 7
Related commands
display poe pse
poe legacy enable
Use poe legacy enable to enable a PSE to detect nonstandard PDs.
Use undo poe legacy enable to restore the default.
Syntax
poe legacy enable pse pse-id
undo poe legacy enable pse pse-id