HP MSR4080 User Manual

439
info-center source
Use info-center source to configure a log output rule for a module.
Use undo info-center source to restore the default.
Syntax
info-center source { module-name | default } { console | logbuffer | logfile | loghost | monitor } { deny
| level severity }
undo info-center source { module-name | default } { console | logbuffer | logfile | loghost | monitor }
Default
Table 92 lists the default log output rules.
Table 92 Default output rules
Destination
Source
modules
Common log Security log Diagnostic log Hidden log
Console
All supported
modules
debugging Disabled Disabled Disabled
Monitor
terminal
All supported
modules
debugging Disabled Disabled Disabled
Log host
All supported
modules
informational Disabled Disabled informational
Log buffer
All supported
modules
informational Disabled Disabled informational
Log file
All supported
modules
informational Disabled Disabled informational
Security log
file
All supported
modules, cannot
be filtered
Disabled
Debugging, which
cannot be filtered
Disabled Disabled
Diagnostic
log file
All supported
modules, cannot
be filtered
Disabled Disabled
Debugging,
which cannot be
filtered
Disabled
Views
System view
Predefined user roles
network-admin
Parameters
module-name: Specifies a module by its name. For instance, to output FTP information, set this argument
to FTP. You can use the info-center source ? command to view the modules supported by the device.
default: Specifies all modules, which can be displayed by using the info-center source ? command.
console: Outputs logs to the console.
logbuffer: Outputs logs to the log buffer.
logfile: Outputs logs to a log file.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English