HP MSR4080

415
[Sysname-GigabitEthernet2/0/1] sflow sampling-rate 4000
Related commands
sflow sampling-mode
sflow source
Use sflow source to specify the source IP address of sFlow packets.
Use undo sflow source to restore the default.
Syntax
sflow source { ip ip-address | ipv6 ipv6-address } *
undo sflow source { ip | ipv6 } *
Default
The source IP address of sent sFlow packets is determined by routing.
Views
System view
Predefined user roles
network-admin
Parameters
ip ip-address: Specifies the source IPv4 address of sFlow packets.
ipv6 ipv6-address: Specifies the source IPv6 address of sFlow packets.
Examples
# Specify the source IPv4 address of sFlow packets as 10.0.0.1.
<Sysname> system-view
[Sysname] sflow source ip 10.0.0.1