HP MSR4080

441
Examples
# Enable synchronous information output, and then issue the display current-configuration command to
view the current configuration of the device.
<Sysname> system-view
[Sysname] info-center synchronous
Info-center synchronous output is on
[Sysname] display current-
At this time, the system receives log information. It displays the log information first, and then displays
your previous input, which is display current- in this example.
%May 21 14:33:19:425 2007 Sysname SHELL/4/LOGIN: VTY login from 192.168.1.44
[Sysname] display current-
Enter configuration to complete the display current-configuration command, and press the Enter key to
execute the command.
# Enable synchronous information output, and then save the current configuration (enter interactive
information).
<Sysname> system-view
[Sysname] info-center synchronous
Info-center synchronous output is on
[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:
At this time, the system receives the log information. It displays the log information first and then displays
[Y/N].
%May 21 14:33:19:425 2007 Sysname SHELL/4/LOGIN: VTY login from 192.168.1.44
[Y/N]:
Enter Y or N to complete your input.
info-center timestamp
Use info-center timestamp to configure the timestamp format for logs sent to the console, monitor
terminal, log buffer, and log file.
Use undo info-center timestamp to restore the default.
Syntax
info-center timestamp { boot | date | none }
undo info-center timestamp
Default
The timestamp format for logs sent to the console, monitor terminal, log buffer, and log file is date.
Views
System view
Predefined user roles
network-admin