HP MSR4080

177
specified-engineid engineid: Uses a user-defined engine ID to calculate the ciphertext key. The engineid
argument specifies an SNMP engine ID as a hexadecimal string. It must contain an even number of
hexadecimal characters, in the range of 10 to 64. All-zero and all-F strings are invalid.
Usage guidelines
Make sure the SNMP agent is enabled before you execute the snmp-agent calculate-password
command.
For security purposes, use this command to calculate digests for ciphertext authentication and privacy
keys when you create SNMPv3 users by using the snmp-agent usm-user v3 command.
The converted key is valid only under the engine ID specified for key conversion.
Examples
# Use the local engine and the SHA-1 algorithm to calculate a digest for the ciphertext key converted
from the plaintext key authkey.
<Sysname> system-view
[Sysname] snmp-agent calculate-password authkey mode sha local-engineid
The encrypted key is: 09659EC5A9AE91BA189E5845E1DDE0CC
Related commands
• snmp-agent local-engineid
• snmp-agent usm-user v3
snmp-agent community
Use snmp-agent community to configure an SNMP community.
Use undo snmp-agent community to delete an SNMP community.
Syntax
In VACM mode:
snmp-agent community { read | write } [ simple | cipher ] community-name [ mib-view view-name ] [ acl
{ acl-number | name acl-name } | acl ipv6 { ipv6-acl-number | name ipv6-acl-name } ] *
undo snmp-agent community { read | write } [ cipher ] community-name
In RBAC mode:
snmp-agent community [ simple | cipher ] community-name user-role role-name [ acl { acl-number |
name acl-name } | acl ipv6 { ipv6-acl-number | name ipv6-acl-name } ] *
undo snmp-agent community [ cipher ] community-name
Default
No SNMP community exists.
Views
System view
Predefined user roles
network-admin