HP MSR4080

292
Usage guidelines
You must execute this command for a CLI-defined policy to take effect.
After changing the settings in a policy that has been enabled, you must re-execute this command for the
changes to take effect.
Examples
# Enable the CLI-defined policy test.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] commit
display rtm environment
Use display rtm environment to display user-defined EAA environment variables and their values.
Syntax
display rtm environment [ var-name ]
Views
Any view
Predefined user roles
network-admin
Parameters
var-name: Specifies a user-defined EAA environment variable by its name. If you do not specify a
variable, this command displays all user-defined EAA environment variables.
Examples
# Display all user-defined EAA environment variables.
<Sysname> display rtm environment
Name Value
config_cmd interface m2/0/1
save_cmd save main force
show_run_cmd display current-configuration
display rtm policy
Use display rtm policy to display monitor policies.
Syntax
display rtm policy { active | registered [ verbose ] } [ policy-name ]
Views
Any view
Predefined user roles
network-admin
Parameters
active: Displays policies that are running.