HP MSR4080 User Manual

143
Status : Normal
PoE Power Supply 2:
Manufacturer : Tyco Electronics Com
Type : PSE2500-B
Status : Normal
Table 29 Command output
Field Description
Chassis 1 Information for member device 1. (Distributed devices in IRF mode.)
Slot 1 Information for member device 1. (Centralized devices in IRF mode.)
PoE Current Power Current PoE power.
PoE Average Power Average PoE power.
PoE Peak Power Peak PoE power.
PoE Max Power Maximum PoE power.
PoE Nominal Power Nominal PoE power.
PoE Current Electric Current Current PoE current.
PoE Current Voltage Current PoE voltage.
PoE Lower Input Threshold AC input under-voltage threshold.
PoE Upper Input Threshold AC input over-voltage threshold.
PoE Lower Output Threshold DC output under-voltage threshold.
PoE Upper Output Threshold DC output over-voltage threshold.
PoE Hardware Version PoE hardware version number.
PoE Software Version PoE software version number.
PoE Power Supplies Number of PoE power supply units.
Manufacturer
Manufacturer of the PoE power. This field displays NONE if the device
cannot obtain manufacturer information.
Type
Type of the PoE power. This field displays NONE if the device cannot
obtain type information.
Status
PoE power status:
• Normal—The PoE power supply is operating correctly.
• Absent—The PoE power supply is not present.
• Off—The PoE power is turned off.
• Active—The active PoE power supply is operating correctly.
• Standby—The standby PoE power supply is operating correctly.
• Balanced—The PoE power supply is operating in load balancing
mode.
• Redundant—The PoE power supply is operating in redundancy
mode.
• Alarm—An alarm was triggered.
• Faulty—A fault occurred.

HP MSR4080 Specifications

General

Brand	HP
Model	MSR4080
Category	Network Router
Language	English