225
Use undo rmon statistics to remove an entry from the RMON statistics table.
Syntax
rmon statistics entry-number [ owner text ]
undo rmon statistics entry-number
Default
No entry exists in the RMON statistics table.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
entry-number: Specifies a statistics entry index in the range of 1 to 65535.
owner text: Specifies the entry owner, a case-sensitive string of 1 to 127 characters.
Usage guidelines
You can create RMON statistics entries only for Layer 2 or Layer 3 Ethernet interfaces.
You can create one statistics entry for each Ethernet interface, and a maximum of 100 statistics entries on
the device.
Each RMON statistics table entry provides a set of cumulative traffic statistics collected up to the present
time for an interface. Statistics include number of collisions, CRC alignment errors, number of undersize
or oversize packets, number of broadcasts, number of multicasts, number of bytes received, and number
of packets received. The statistics are cleared at a reboot.
To display the RMON statistics table, use the display rmon statistics command.
Examples
# Create an RMON statistics entry for GigabitEthernet 2/0/1. The index is 20 and the owner is user1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] rmon statistics 20 owner user1
Related commands
display rmon statistics
To Next Page
Loading...
Need help?
General
