HP ProCurve 1810G User Manual

9-1
9
Diagnostics
Ping Test
Use the Ping Test page to determine whether another device on the network is reachable. Ping provides
a synchronous response when initiated.
To display the Ping Test page, click Diagnostics > Ping Test in the navigation pane. The following example
shows the output of the ping test.
Figure 9-1. Ping Test Page
Table 9-1. Ping Test Fields
Field Description
IP Address Specify the IP address of the host you want to reach.
Count Specify the number of packets to send. (Range 1 - 5 packets, Default = 1)
Interval Specify the delay between ping packets. (Range 1–60 seconds, Default = 3 seconds)
Size Specify the size of the ping packet to be sent. (Range 0–5120, Default = 0)

HP ProCurve 1810G Specifications

General

Model	HP ProCurve 1810G
Layer	Layer 2
Power Supply	Internal
VLAN Support	Yes, up to 256 VLANs
Ports	8 or 24 10/100/1000 ports
Management	Web-managed
Switching Capacity	16 Gbps (8-port), 48 Gbps (24-port)
Form Factor	Rack-mountable
Forwarding Rate	11.9 Mpps (24-port model)
Jumbo Frame Support	Yes
Quality of Service (QoS)	Yes
Operating Temperature	0°C to 40°C
Operating Humidity	15% to 95% non-condensing