HP ProCurve 1810G User Manual

3-4
Network Setup
Time Zone
■ Click Apply to save any changes for the current boot session; the changes take effect
immediately. Use the Maintenance > Save Configuration page to have the setting remain in effect
after a reboot.
■ Click the Refresh link above the page to re-display the page with current settings from the
switch.
To view a summary of clock information, click Status > Clock in the navigation pane.
Time Zone
Use this page to configure your local time zone. The switch must be configured to acquire the time
from an SNTP server.
To display the Time Zone page, click Network Setup > Time Zone in the navigation pane.
Figure 3-3. Time Zone Page
Table 3-3. Time Zone Fields
■ Click Apply to save any the changes for the current boot session; the changes take effect
immediately. Use the Maintenance > Save Configuration page to have the setting remain in effect
after a reboot.
■ Click the Refresh link above the page to re-display the page with current settings from the
switch.
To view a summary of clock and time zone information, click Status > Clock in the navigation pane.
Field Description
Time Zone Select the time zone for your location.
Acronym Specify an acronym for the time zone.

HP ProCurve 1810G Specifications

General

Model	HP ProCurve 1810G
Layer	Layer 2
Power Supply	Internal
VLAN Support	Yes, up to 256 VLANs
Ports	8 or 24 10/100/1000 ports
Management	Web-managed
Switching Capacity	16 Gbps (8-port), 48 Gbps (24-port)
Form Factor	Rack-mountable
Forwarding Rate	11.9 Mpps (24-port model)
Jumbo Frame Support	Yes
Quality of Service (QoS)	Yes
Operating Temperature	0°C to 40°C
Operating Humidity	15% to 95% non-condensing